Yukon Pinion Install Kit For 2010 And Down GM And Chrysler 11.5 Inch Yukon Gear & Axle
Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings and races can be reused. This kit uses Timken bearings and races along with high quality seals and small parts. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your gear set.
Details:
- Fits 2010 and down GM and Chrysler 11.5 inch
- Included are Pinion Bearings and races, pinion seal, crush sleeve, complete pinion shim kit, and marking compound with brush
- 1 Year Warranty Against Manufacturer Defects
- Sold As A Kit
Technical Notes:
- In mid 2011 the design for the Pinion Bearing changed
- The early design had a rear pinion race O.D. of 4.125 inches
- The later design has an O.D. of 4.375 inches
- This kit is the 4.125 inch design
Fits Vehicles:
- Chevrolet Silverado 2500 3/4 Ton (2001 - 2010)
- Chevrolet Silverado 3500 1 Ton (2001 - 2010)
- Chevrolet Silverado HD 2500 3/4 Ton (2001 - 2010)
- Chevrolet Silverado HD 3500 1 Ton (2001 - 2010)
- Dodge Ram 2500 3/4 Ton (2003 - 2010)
- Dodge Ram 3500 1 Ton (2003 - 2010)
- Dodge Ram Van 2500 3/4 Ton (2003 - 2003)
- GMC Sierra 2500 3/4 Ton (2001 - 2010)
- GMC Sierra 2500 HD 3/4 Ton (2001 - 2010)
- GMC Sierra 3500 1 Ton (2001 - 2010)
- GMC Sierra 3500 HD 1 Ton (2001 - 2010)
