SWAG PERFORMANCE

Fuel Injector Hold Down Bolt Set (8) | 2011-2022 Ford 6.7L Powerstroke Diesel

Fuel Injector Hold Down Bolt Set (8) | 2011-2022 Ford 6.7L Powerstroke Diesel

SWAG PERFORMANCE

Write a Review
SKU:
SWF-00812-OE
Width:
8.00 (in)
Height:
4.00 (in)
Depth:
4.00 (in)
Now: $39.95
Adding to cart… The item has been added

Replacing fuel injectors on your 2011–2022 Ford 6.7L Powerstroke Diesel? New injector hold-down bolts are a required part of the installation.

The factory Ford injector hold-down bolts are torque-to-yield (TTY) fasteners designed for a single installation. During tightening, the bolts undergo controlled stretching to establish the specified clamping force. Once installed and removed, these bolts cannot be reused.

This SWAG Performance eight-piece injector hold-down bolt kit provides the new hardware required when replacing or removing fuel injectors on the 6.7L Powerstroke Diesel.

Each bolt secures an injector hold-down clamp to the cylinder head, maintaining the clamping force necessary for proper injector seating and combustion sealing.

One kit includes all eight bolts needed for a complete engine's injector installation.

Vehicle Fitment

2011–2022 Ford 6.7L Powerstroke Diesel

  • Ford F-250 Super Duty

  • Ford F-350 Super Duty

  • Ford F-450 Super Duty

  • Ford F-550 Super Duty

For applicable 6.7L Powerstroke Diesel engines using the referenced factory injector hold-down hardware.

OEM Part Number References

  • BC3Z-00812-B

  • FC3Z-00812-AA

Why Are New Injector Hold-Down Bolts Required?

The 6.7L Powerstroke uses torque-to-yield injector hold-down bolts to secure the fuel injectors within the cylinder heads.

Unlike conventional reusable fasteners, TTY bolts are tightened using a specified torque-and-angle procedure that stretches the bolt to develop the required clamping load.

This controlled stretching changes the fastener's installed condition. Once a bolt has been tightened and subsequently removed, it is not intended for a second installation.

Reusing previously installed injector hold-down bolts can result in improper clamping force, bolt failure, or injector sealing problems.

Insufficient clamping force may allow injector movement or combustion gas leakage around the injector seat, potentially damaging the injector and cylinder head sealing surfaces.

Anytime a fuel injector is removed, a new hold-down bolt should be used during reinstallation.

Whether you are replacing a single failed injector or installing a complete set of eight, new mounting hardware is an essential part of completing the repair correctly.