BANKS POWER

2004.5-2007 DODGE 5.9L CUMMINS BANKS POWER EXHAUST BRAKE (DODGE 5.9L)

2004.5-2007 DODGE 5.9L CUMMINS BANKS POWER EXHAUST BRAKE (DODGE 5.9L)

BANKS POWER

Write a Review
SKU:
55225 / 55226 / 55227 / 55228 / 55229
Width:
16.00 (in)
Height:
35.00 (in)
Depth:
17.00 (in)
$1,389.00 - $1,879.00
Adding to cart… The item has been added

* Please call for availability

2004.5-2007 DODGE 5.9L CUMMINS

 

Banks Brake® 04.5-07

(04 1/2-07) A total system solution with enhanced transmission control for exhaust braking, Banks' direct-mount, no-maintenance exhaust brake has electronics that monitor critical engine and transmission parameters to maximize braking efficiency. It dramatically cuts downhill speeds without using the wheel brakes. This keeps brakes cool and ready for emergencies, and saves thousands in brake maintenance. Optimizes exhaust flow when not engaged. Easy install; needs no drilling, cutting or modifications to stock wiring.

(Automatic Transmissions only) Computerized brake control (CBC) and SmartLock are included. CBC automatically senses throttle position, controls brake engagement and cuts out annoying brake noises. Fast warm-up function prolongs brake durability, and automated brake disengagement at low speed smoothes stop-and-go driving. Banks SmartLock locks the torque converter & raises line pressure to smoothly reduce vehicle speed and safeguard the transmission.

 

Cast, large-bore brake housing assembly; High-force 41/4" vacuum actuator; Belt-driven vacuum pump with serpentine belt for quiet operation; Computerized Brake Controller/SmartLock; Large butterfly valve with super-alloy shaft-and-bearing system; Wire loom; Mounting hardware.

 
 
 

5-Year Ltd. Warranty Brake assembly*

 

2-Year Ltd. Warranty Electrical components, pneumatic components, solenoid valve and auxilliary air supplies (where applicable)

*Ltd. warranty does not cover service conditions (i.e. soot buildup in shaft bushings due to out-of-tune engine, or excess heat-damage due to overly-rich fueling conditions)

 

04.5+ Automatic: Please Verify that your vehicle is equipped with a transmission throttle valve assembly and that NO Throttle Position sensor assembly is installed to have the CBC/ SmartLock function properly.

*For 2004 Automatic: If your vehicle is not equipped with a Transmission Throttle Valve Assembly but has a throttle position sensor located in the engine compartment on the drivers side towards the front of the engine and the three transmission connectors on the driver's side of the transmission you will need system part #55229 for your Banks CBC/SmartLock to function properly.